The bolt anchor is also suitable for stand-off installation as well as pre-positioned and in push-through installation. The stainless steel version of the bolt anchor is suitable for fixing faasade sub-structures, consoles, and ladders in external areas.

Top Features

• With assessment document (ETA) the hot dipped galvanized steel version is covered for external use with variable working life depending on environment and corrosion conditions.
• The FBN II achieves maximum load-bearing capacity with standard anchorage depth. This means: fewer fixing points and smaller anchor plates.
• If the reduced anchorage depth is used, then this lowers the drill hole depth and simplifies installation.
• Component tolerances are balanced out with the long thread. In addition, FBN II is also suitable for stand-off installations. This increases flexibility.
• Simple assembly due to few taps and minimal slippage.

Advantages

• The standard anchorage depth achieves the maximum load-bearing capacities. This means that fewer fixing points and smaller anchor plates are required.
• The reduced anchorage depth reduces the drill hole depth. This minimises the amount of time needed for installation whilst increasing flexibility.
• The first bolt anchor with variable working life covers the usage of bolt anchors in wet conditions and outdoor areas.
• The long thread balances component tolerances and stand-off installations, and thus increases flexibility.
• Fewer hammer blows and the minimal torque slippage allow for a noticeably simpler assembly.
• The drive-in pin protects the threaded screw from damage, and as such ensures a faster installation and dismantling of the fixture.